Privacy Release 2-255
Features and Operation
STARPLUS STSe - Programming & Operations Manual August 2005
Programming Steps
1. Press FLASH and dial [40]. The following message displays:
2. Enter a valid number for the range of lines being programmed. If only one line is being
programmed, enter that number twice (001 001).
3. Press HOLD to save the entry. A confirmation tone sounds and the display updates.
Flexible button #19 (Page A) is lit. The following message displays to indicate current
programming of that line or group of lines:
XXX-XXX = CO Line Range
4. Press the PRIVACY flexible button (Button #5).
5. Enter a 0 or 1 on the dial pad to enable/disable this feature.
[0] = Disabled
[1] = Enabled
6. Press HOLD to save the entry. A confirmation tone sounds.
Disabling Privacy Function:
The system can be programmed to eliminate CO Line Privacy, which allows another station to
join existing outside line conversations as follows:
Stations must have a direct CO line appearance to join CO line conversations in progress.
A station must also have Privacy disabled before the system allows that station to enter
an existing conversation.
A programmed warning tone is presented to both parties prior to actual cut-through
(Flash 06, Button 1).
Up to seven other stations may join an existing conversation.
The station joining the call receives a solid red LED indication.
DEFAULT … Privacy is enabled for all CO Lines.
CO LINE ATTRIBUTES
SELECT A CO LINE RANGE
If HOLD is pressed without entering a CO line range, all CO lines are selected.
XXX - XXX PAGE A
ENTER BUTTON NUMBER
PRIVACY 0-1
ENABLED
Disabling the privacy feature may be limited by federal, state or local law, so
check the relevant laws in your area before disabling privacy.
To Next Page
