Attendant Directory List Programming 3-11
Attendant Features and Operation
STARPLUS STSe - Programming & Operations Manual August 2005
The following procedure is used to associate names to a system speed dial bin only.
1. Enter desired 3-digit Directory List number (000-199), or dial [
] to scroll up (next entry)
or [#] to scroll down (previous entry) through the list.
If changing a name associated with an existing System Speed Dial Bin entry, go to step 4.
2. Press TRANS.
3. Dial system speed dial bin location (9020-9099).
4. Press MUTE.
5. Use keys on the dial pad to enter the name (up to 24 characters may be entered). The
display will update as the name is entered (refer to Figure 3-1 on page 3-10).
6. Press SPEED when finished. Confirmation tone sounds and the display updates.
7. Press HOLD, then use [
] or [#] to scroll to next entry.
-or-
Hang up to end programming.
Operation
To view the directory list:
1. Dial the Directory List dial code [680] on the dial pad,
-or-
Press the flexible button programmed as a directory dialing button.
2. Press a button on the key pad, once, twice or three times, that represents the letter of the
alphabet to begin viewing the list of names (e.g., when 2 is first pressed, it produces
names starting with A. When 2 is pressed a second time, names that start with B display.
Pressing 2 a third time displays names that start with C). The alphabet is represented on
the key pad as shown below.
Names beginning with the letter chosen display on the LCD display.
If there are no names in the Directory List beginning with the desired letter, a
name with the next higher letter displays on the LCD display.
1
A-2
B-2
C-2
D-3
E-3
F-3
G-4
H-4
I-4
J-5
K-5
L-5
M-6
N-6
O-6
P-7
R-7
S-7
T-8
U-8
V-8
*
OPER
#
0
Q-7
W-9
X-9
Y-9
Z-9
To Next Page
Loading...
