E-4 Introduction
Customer Database Programming
STARPLUS STSe - Programming & Operations Manual August 2005
When using a PC to program the system, the following chart presents the data terminal
characters that are equivalent to the key set buttons.
Figure E-1: Data Terminal Program Codes Cross Reference
Some features must have more than one data field programmed for that feature
to work. This information is stated in the instructions.
adm>
REMOTE ADMIN KEY DEFINITION
Keyset Term Keyset Term Keyset Term
---------------------------------------------
0 0 FLEX 1 Q FLEX 13 D
1 1 FLEX 2 W FLEX 14 F
2 2 FLEX 3 E FLEX 15 G
3 3 FLEX 4 R FLEX 16 H
4 4 FLEX 5 T FLEX 17 J
5 5 FLEX 6 Y FLEX 18 K
6 6 FLEX 7 U FLEX 19 L
7 7 FLEX 8 I FLEX 20 :
8 8 FLEX 9 O FLEX 21 Z
9 9 FLEX 10 P FLEX 22 X
* * FLEX 11 A FLEX 23 C
# # FLEX 12 S FLEX 24 V
TRANS B MUTE N ON-OFF M
FLASH ‘ HOLD CR
adm>
:
,
HELP
?
To Next Page
Loading...
