Volvo Penta EVC EC -C - Other Special Equipment

Other special equipment
The tools below are intended for use in work on the cable harnesses of the engine. The tools are not included in
Volvo Penta’s range, they must be ordered from a local AMP or Deutsch dealer. If you experience problems in
contacting a dealer, please contact Volvo Penta Quality Action Center for advice.
Deutsch connectors
HDT-48-00 Crimping tool
0411-310-1605 Disassembly tool
16-pin CPC connector, d=1.6 mm (0.063")
725 840-1 Disassembly tool
58 495-1 Crimping tool
JPT connector (42-pin EDC, 2 and 3-pin
Bosch etc.)
726 534-1 Disassembly tool 1.6 mm (0.063")
pin width
726 519-1 Disassembly tool 2.8 mm (0.11")
pin width
825 514-1 Crimping tool
Blades and sockets 3.5 mm (0.14")
725 9380 Disassembly tool
825 582-2 Crimping tool
4.8 mm (0.19") and 6.3 mm (0.25") cable clamps.
Tongues and socket terminals
825 514-1 Crimping tool
Deutsch service kit incl. connectors and crimping
tool
11 666 200 NOTE! Volvo Part no. only
AMP 726 519
AMP 825 514 AMP 825 582AMP 725 938
AMP 725 840
AMP 726 534AMP 58 495HDT-48-00
14