Wacker Neuson E3000 User Manual

wc_tx002070gb.fm
131
E 3000 Burner Setup—Gas
Continued from the previous page.
7. Check the pressure reading on the manometer. See section Technical Data for
the correct pressure. Adjust the supply gas pressure as needed.
8. After the supply gas pressure has been set, turn off the supply gas.
9. Remove the manometer and the nipple.
10.Re-install the plug.
11.Perform a leak test at the plug.
Result The supply gas pressure has now been checked and adjusted.

Wacker Neuson E3000 Specifications

General

Brand	Wacker Neuson
Model	E3000
Category	Heater
Language	English