Auxiliary equipment
HAMM line spreader
222
BA RD40_RD45 en 00
NOTICE
Sticking gritting material!
Blocked spreader shaft, material damage or destruction of the driving
elements.
■
Completely open the spreader apertures before switching on the
spreader rotor.
■
With the machine is at a standstill, only allow the spreader rotor to
start with a low speed, and increase to working speed after a short
time.
■
Set the spreader apertures to the working cross-section.
Adjusting the stop valve
Depending on the size of the spreader openings [1], more or less gritting
material will flow out of the storage tank. Grit grain size and discharge
quantity exert an influence on the opening cross-section to be selected.
Use the shut-off slider [2] to adjust the openings in the gritting bottom.
Set the shut-off slider [2] to the MIN position.
a
The spreader openings [1] are closed.
Gradually move the shut-off slider [2] towards the MAX position.
a
The spreader openings [1] are opened gradually.
a
Use the adjustable stop [4] at the scale [3] to repeat an opening
setting already determined beforehand.
When spreading operations are complete, close the spreader
openings (shut-off slider to MIN position) to prevent more gritting
material from flowing out.
Option for electric operation of the stop valve
For versions with the ROPS cab, the stop valve can optionally be moved
electrically from inside the cab.
This does not affect any of the processes described.
To Next Page
Loading...
Need help?
General
