Wayne 4310 - Measurement; Figure 4-10 Short Circuit Trim Page; Figure 4-11 Short Circuit Trim in Progress

Operation 4–11
Figure 4-10 Short Circuit Trim Page
5) Short-circuit the Kelvin clips (see Fig 4-6) and press Enter. If required, use the Navigation
Keys to select Cancel and then press Enter.
6) The instrument will display the following message while the short-circuit trim routine is
being performed:
Figure 4-11 Short Circuit Trim in progress
7) When the S/C trim has been completed, the instrument will return to the last measurement
screen.
4.4 Measurement
The instrument should be powered up with the test leads or fixture connected to the front panel
BNC connectors. If the test leads or fixture have been changed since the instrument was last
used, the instrument should be trimmed as described in section 4.3.