Wayne 4310 - Range; DC Resistance; Figure 4-27 Hardware Range Selection Page; Figure 4-28 Rdc Measurement Screen

Operation 4–21
4.4.14 Range
When Range has been selected from the Set Pull Down Menu, the following page will be
displayed:
Figure 4-27 Hardware Range Selection Page
The required range setting should be selected by using the Navigation Keys to highlight the
appropriate setting, and then press Enter.
The display will then show the user selected range setting, followed by the range used to make
the last measurement. In the example above, the user has selected Auto and the last
measurement was made using Range 4.
Auto range automatically selects the most accurate range for the measurement.
4.4.15 DC Resistance
When Rdc has been selected from the Function 1 Selection Page, the following page will be
displayed:
Figure 4-28 Rdc Measurement Screen