Wayne 4310 - Figure 4-45 One Term Dual Limits Absolute Limits Screen; Figure 4-46 One Term Dual Limits Percentage Limits Screen

Operation 4–32
4.4.24.2 Binning – Setting One Term Dual Limits
One of two screens will be displayed when the One Term Dual Limits Binning Type has been
selected, depending on whether the last limits used were Absolute or Percentage:
Figure 4-45 One Term Dual Limits Absolute limits screen
Figure 4-46 One Term Dual Limits Percentage Limits screen
The Limits 1/2 soft key is used to toggle between LL1/HL1 and LL2/HL2 limits in order to set
them. LL1 and HL1 can be set when L1 is shown in the box on the left side of the screen, and
LL2 and HL2 can be set when L2 is shown in the box.
The Abs/Perc soft key (Absolute/Percentage) is used to toggle between setting the limits as
either Absolute limits or Percentage limits.
The High Limit soft key is used to enter HL1 and HL2 limits. After pressing the High Limit
soft key, enter the required value using the numerical key pad. After entering the first digit for
Absolute Limits, the soft keys will change and offer a variety of multiplier units (as a short cut)
for the parameter being set. For example, when the active Term is C(apacitance), the soft keys
will display pF, nF, uF and mF. Alternative the full numerical value can be entered and then
confirmed by pressing the Enter key.
For example, a limit of 1µF can be entered as either 1 uF or 0 . 0 0 0 0 0 1 Enter.