Safety Regulations 40075165 Markoprint integra PP108
Page 12 of 104 GB
Intended Use
The working reliability of the print system is ensured only with intended use.
The Markoprint integra PP108 has been designed, built and must be used exclusively for
the intended purpose described.
The Markoprint integra PP108 serves to create print images and to print these from the
top or side onto smooth and absorbent product surfaces. The product must pass the
Markoprint integra PP108, i.e. positioned on a conveyor belt.
All working conditions and instructions, prescribed in this manual, will be observed.
Any use beyond the intended use or any alternative use of the equipment is regarded as
misuse and may lead to hazardous situations.
Misuse of the device may lead to hazardous situations. Refrain, in particular, from
subjecting the apparatus to the following:
Modification, retrofitting or alteration of the apparatus or individual sub-
assemblies.
Any claims arising from damages due to undesignated use are rejected.
Reasonably Foreseeable Misuse
Another use as fixed in the „Intended Use“ or even more applies as not intended!
For damages caused by not intended use
the operator bears the complete responsibility,
the manufacturer assumes no liability.
If you do not use the system according to the regulations, risks may occur!
Not intended uses are e.g.:
operation in explosive atmosphere
the print system comes in contact with food …
To Next Page
Loading...
Need help?
General
