Weber Markoprint integra PP108 - Settings by Idesign Software

Operation 40075165 Markoprint integra PP108
Page 75 of 104 GB
Settings by iDesign software
Following print parameter can set up with the iDesign software (Note the instructions of
the provided iDesign software manual):
 Print start delay
 Print direction
 Overhead
 Zoom
 Fixed speed
 Speed (Only adjustable if fixed speed is adjusted)
 Intensity (Only adjustable if fixed speed is adjusted)
 Shaft encoder
 Shaft encoder resolution (only adjustable if shaft encoder is adjusted)
 Shaft encoder divider (only adjustable if shaft encoder is adjusted)
Fig. 35: Set print parameter by iDesign