Installation and Initial Operation 40075165 Markoprint integra PP108
Page 37 of 104 GB
Installation and Initial Operation
Safety notes
Danger to life through electric shock!
Contact with live parts poses imminent danger to life.
Damaged insulation or individual components can be
lethal.
Therefore:
– Immediately switch off the power supply and initiate
repairs if the insulation is damaged.
– Work on the electrical system may only be performed
by electricians.
– Before working on the electrical system, disconnect
from the mains (remove mains plug) and check that
power is off.
– Always disconnect mains before performing cleaning
and repair tasks.
– Keep moisture from live parts. Moisture may cause a
short-circuit.
Risk of stumbling posed by dirt, objects lying about
and connecting lines!
Dirt, objects lying about and connecting lines for power,
data- and signal lines may cause slipping and stumbling
resulting in severe injuries.
Therefore:
– Always keep working area clean.
– Remove objects no longer required.
– Mark stumbling areas with yellow-black marking tape.
– Non tension connecting lines to system and pass it
that no places of danger do arise
To Next Page
Loading...
Need help?
General
