Weber Markoprint integra PP108 - Appendix; Software Updates and USB Files

Appendix 40075165 Markoprint integra PP108
Page 90 of 104 GB
Appendix
Software-Update
Software-update with USB-Stick
Requirements
 The program directories „HMI“, „Html“ and „SYSTEM“ are copied in the main
directory of an empty USB-stick.
 The Markoprint integra PP108 is not connected to the power supply.
Instruction
Please proceed the software-update as follows:
Step
Procedure
1
Connect the Markoprint integra PP108 with the power supply and press the
[Ink]-button simultaneously and press it as long as the Sensor LED flashes
green/red.
2
Connect the USB-stick in the USB socket on the top side of the system.
3
The Sensor LED flashes yellow/red if the program is load.
4
Confirm by pressing the start-button and wait until the system is restart.
5
Remove now the USB-stick.
Software-Upgrade
A software upgrade with costs is comfortably possible via the Weber Marking Partner
Portal
Please contact you distributor for a software upgrade.
You can find a detailed instruction of the software upgrade below the search key
„Configuration upgrade“ in the Wiki of Weber Marking Partner Portal.
Current software version
Status
Date
Reason for change
3.023
01.02.2019