Operation 40075165 Markoprint integra PP108
Page 58 of 104 GB
Switch off
Requirements
The print system is connected with power and switched on
Instruction
Please switch the print system off as follows:
Press the Power button for approx. 10 seconds. The Status, 123 and Ink
LEDs will flash yellow.
After approx. one minute the LEDs flash green and the pumps stop running.
Set the switch from I to 0 on the back of the device.
Fig. 20: ON-/OFF-BUTTON on the back side of the system
The system is switched off completely and starts into the last operating
status the next time it is switched on.
The locking clamp is not mounted.
To Next Page
Loading...
Need help?
General
