Weber Markoprint integra PP108 - To Set the Print Start Delay

Operation 40075165 Markoprint integra PP108
Page 65 of 104 GB
To set the print start delay
It’s possible to change the print start delay at the system with a key combination.
Instruction
Please set the print start delay at the system as follows:
Step
Procedure
1
Press the [SELECT]-Button and the [ON-/OFF]-Button to increase the print
start delay.
Fig. 30: SELECT-BUTTON and ON-/OFF BUTTON
2
The delay increase by 1 mm each time the button is pressed.
3
Press the [SELECT]-Button and [INK]-Button to decrease the print start
delay.
Fig. 31: SELECT-BUTTON and INK-BUTTON
4
The delay decrease by 1 mm each time the button is pressed.