Weber Markoprint integra PP108 User Manual

Installation and Initial Operation 40075165 Markoprint integra PP108
Page 53 of 104 GB
Installation of an unfilled system
The systems are delivered ready filled with ink.
If a system for some reason is delivered unfilled, proceed as follows:
Instruction
Please fill the system with ink as folows:
Step
Procedure
1
Install the Markoprint integra PP108 (head and ink system) stable and
horizontal on a mounting bracket.
2
Connect the system with the power supply.
3
Switch on the power.
4
The ink LED and status LED should light yellow after start up, because the
ink tank is empty.
5
Screw in the ink bottle until the seal is open and wait until the bottle has
emptied.
Pay attention to the correct ink type!

Weber Markoprint integra PP108 Specifications

General

Brand	Weber
Model	Markoprint integra PP108
Category	Printer
Language	English