Installation and Initial Operation 40075165 Markoprint integra PP108
Page 52 of 104 GB
Requirements
The nozzle plate is NOT dry (Rinsing or spary on the cleaning agent, leave to act briefly
and carry out the rinsing process)
Instruction
Please wipe the nozzle plate as follows:
Wipe over the nozzle plate in one go and in one direction. Do not apply any
pressure to the nozzle plate.
Fig. 15: Wiping the nozzle plate
After rinsing, a test print should be done. If the print result is not satisfactory,
repeat steps bleeding and rinsing.
If the contamination is too stubborn and cannot be removed by the rinsing
procedure, return the unit to our factory for expert cleaning. Please note that this
constitutes a service which entails costs, even during the warranty period.
If the normal unit environment is constantly subject to large dust accumulation,
we recommend having the unit cleaned at the factory in regular intervals of once
or twice per year.