Operation 40075165 Markoprint integra PP108
Page 57 of 104 GB
Switch on
Requirements
The print system is connected with power.
Instruction
Please switch the print system on as follows:
Set the switch from 0 to I on the back of the system.
Fig. 19: ON-/OFF-BUTTON on the back side of the system
The system must conduct a self-test and is ready for operation after ca. 30
seconds.
If the pumps do not start to run in rhythm (return pump continuously, flow
pump pulsed approx. 50%), start the rinsing function once or put on the
locking clamp until the pumps run in rhythm.
To Next Page
Loading...
