Weber Markoprint integra PP108 - Page 54

Installation and Initial Operation 40075165 Markoprint integra PP108
Page 54 of 104 GB
Step
Procedure
Fig. 16: Insert ink bottle
6
The ink should run in the ink tank. If the tank is full, the ink LED lights green.
(This takes up to 30 sec.)
7
Wait 1 -2 minutes until the ink circuit is completely filled and the pumps work
regularly.
8
Remove the locking clamp of the nozzle plate and keep it in a convenient
place.
Fig. 17: Remove locking clamp
9
Assign a print image: Press the [123]-button and the[ON-/OFF]-button. Now
the status LED should light green.