Tech. Dok. / L23 880 02 / 05.99.01 © MICHAEL WEINIG AG
Operation
1-4 Profimat 23 E
Keep out of range of the flying chips. Do not
look into the infeed tunnel. Do not touch any
moving machine parts. Never raise the feed
beam while there is timber in the machine,
otherwise the workpiece will be released and
can be kicked back.
Production in automatic mode
• Set mode selector to "1", automatic mode.
• Set spindle brake to "0", apply brakes.
• Close hood.
Spindle motors and continuous feed can be
switched on.
• Spindle motors "on", continuous feed "on".
Spindles motors and feed are switched off when
the hood is opened.
• Place timber on infeed table and against edge
jointing fence. Feed timber into the machine
end-to-end.
• Stop production via an Emergency OFF if
dangerous situations arise.
Switching off the machine
• Wait until machine is empty
• Spindles, feed, dust extraction and all
supplementary equipment "off"
• Master switch "off"; secure with lock prior to
prolonged shutdowns, repair work or tool
change.
…
To Next Page
Loading...