Tech. Dok. / L23 880 02 / 05.99.01 © MICHAEL WEINIG AG
Setting up profiles
5-3Profimat 23 E
Set-up variation – setting up
in accordance with a sample
profile
Successively set up all profile tools in accordance
with an existing sample profile.
Sample length
The sample profile must be long enough to rest
securely on the next table/fence and extend under/
beside the center axis of the spindle.
Example, top spindle
• Place profiled timber under the top spindle,
against the lateral fence.
Example – axial, radial
• Adjust spindle in axial and radial directions
until the profile tool accurately fits into the
profiled timber.
• Simultaneously turn the tool by hand in the
direction opposite to that of cutting.
Trial run
• After a trial run, correct spindle setting as
described in the chapter entitled "Set-up
variation, planing a test piece".
To Next Page
Loading...