Tech. Dok. / L23 880 02 / 05.99.01 © MICHAEL WEINIG AG
Tools
3-1Profimat 23 E
Safety instructions
When changing tools
Protective gloves must be worn when changing
tools – high risk of injury on sharp cutting
edges. Tools must be fitted with great care.
Assembly / disassembly sequence must be
followed precisely.
• Note the safety instructions and directions in the
following:
– "Instruction Manual, Tools" issued by the tool
manufacturer
– Manual entitled "Safety Instructions"
• Select manual mode and release spindle brakes
for tool changes.
Before switching on the spindles
Note the following checklist:
• Clean all contact surfaces. Pressure points
on the spindle collar must be deburred with a
whetstone.
• Always use a safety locking collar. This is
the only way to ensure that the tools are
adequately prevented from spinning.
• Tighten the spindle nut so that it cannot
work itself loose.
• Before starting the spindles, turn the tool by
hand to ensure it runs smoothly without
interference.
• Spindles may only be switched on when
dust extraction hoods and safety mechanisms
have been fitted.
DANGER
To Next Page
Loading...