Tech. Dok. / L23 880 02 / 05.99.01 © MICHAEL WEINIG AG
Operation
1-1Profimat 23 E
Intended use
Application
The machine is designed and built exclusively for
planing and producing longitudinal profiles on
four sides. All other uses must be approved by the
manufacturer in each instance.
Permissible materials
Standard types of wood and wood substitutes
with outside dimensions (L x W x H) as specified
in the technical data.
Permissible tools
Planing and profiling cutterheads and hydraulic
tools as specified in the technical data and
pr EN 847-1.
Workplaces
The number and position of the workplaces are
shown in the installation diagram; refer to the
order confirmation drawing when material
handling is connected. The main workplace is on
the feed side.
All other uses are deemed to be non-conforming.
For example: sawing and splitting work may only
be carried out with the requisite supplementary
equipment. Machining of metal or similar
materials and operation without duly installed
safety mechanisms are deemed to be non-
conforming uses.
The manufacturer cannot assume any liability for
resultant damage and losses; this risk rests
exclusively with the user.
Conforming use also includes compliance with
the associated Instruction, Service and
Maintenance Manuals.
§§
To Next Page
Loading...