Weinig Profimat 23 E - Air Cushion System

Tech. Dok. / L23 880 02 / 05.99.01 © MICHAEL WEINIG AG
Machine options
6-5Profimat 23 E
2
4
6
8
10
12
14
16
Air cushion
Application
Compressed air is blown under the workpiece via
holes in the machine table. The timber is
transported through the machine on a cushion of
air.
Adjust width of air cushion
Pneumatic circuits (1), (2) and (3) can be
switched in or out in accordance with the timber
width.
• To switch in pneumatic circuit (1):
Set pressure controller on pneumatic control
panel to approx. 2-3.
Set pressure controller to 0 to switch off all
pneumatic circuits.
• To switch pneumatic circuit (2) into circuit (1):
Actuate switch near feed beam (2).
• To switch pneumatic circuit (3) into circuits (1)
and (2):
Actuate switch (3).
(3)
(1)
(2)