Weinig Profimat 23 E - Telescoping Roller Shaft; Guiding Knife Setup

Tech. Dok. / L23 880 02 / 05.99.01 © MICHAEL WEINIG AG
Machine options
6-3Profimat 23 E
Telescoping roller shaft
opposite left-hand spindle
Application
Quick infinite adjustment of the feed roller shaft
to different feed roller widths; max. roller width
50 mm.
Changing feed rollers
• Release clamp on telescoping shaft (2) with
Allen key (1) and infinitely adjust roller shaft to
the width of the feed roller(s) (3).
• Release clamping screw (4) in order to fit
extended roller shaft (2) (optional).
Guiding knife
Application
The guiding knife (1) in the vertical spindle insert
ensures accurate guidance in the spindle area.
The shallow groove is removed from the timber
by the last bottom spindle.
Basic setting
• Release clamping screws (2) of guiding knife
and adjust height of guiding knife to 0.3 mm
above the table via the adjusting screws (3) on
the underside of the insert. Align parallel to
machine fence.
• Set the last bottom spindle to a chip removal of
0.5 mm.
(1)
(2)
(3)
(1)
(2)
(3)
(4)