Tech. Dok. / L23 880 02 / 01.00.02 © MICHAEL WEINIG AG
Einleitung
0-6 Profimat 23 E
Safety
Signs referring to product safety and other safety stickers must be checked regularly and
cleaned. They must be replaced if they are no longer clearly legible, even at a
reasonable distance.
All safety mechanisms must be checked every day and before starting up the machine in
order to ensure that they are always in perfect working order.
Any protective mechanisms which have been removed for setting-up, retooling, repair
or maintenance work must be replaced before switching on the machine.
Hoods, doors and covers must not be opened or maintenance work started until the
machine has been switched off, all rotating parts (tools, feed rollers, etc.) have come to a
complete stop and the machine has been secured so that it cannot be switched on again
inadvertently (lockout or warning sign on the master switch).
Machine parts and safety mechanisms must not be removed, modified or bypassed.
Only original WEINIG replacement parts may be used in the machine.
No liability whatsoever can be assumed for damage and losses due to the use of parts
from other manufacturers or unauthorized changes in the machine.
Loose-fitting garments, long hair, wristwatches, jewellery and gloves can lead to
accidents at work (e.g. snagging, being trapped by rotating tools, feed rollers, etc.).
For this reason:
– Do not wear any loose-fitting garments
– Cover your hair
– Remove wristwatches and jewellery
Ensure that the workplace is kept clean and tidy. Dirt (e.g. oil or wood dust on the
floor) and obstacles can impair your safety.
Wear goggles or a full face mask and use ear protection.
Keep your hands well clear of the feed area!
In order to avoid kickbacks, the width of the feed rolls must be selected in accordance
with the width of the workpiece and the height of the feed rolls must be set in
accordance with the workpiece height to be machined, so that sufficient pressure is
ensured.
The specified cross-sections and the required air velocities and flow rates (see layout
and extraction diagrams) should be noted in conjunction with the extraction of chips and
dust. The extractor system should always be running whenever the machine is in
operation.
To Next Page
Loading...