Tech. Dok. / L23 880 02 / 01.00.02 © MICHAEL WEINIG AG
Maintenance and care
9-3Profimat 23 E
Lubrication with central lubricating
panel (optional)
Many of the lubricating points have been replaced
by a central lubricating panel (1) in front of the
machine table. A few lubricating points must be
lubricated separately, as the panel does not
include all lubricating points.
Maintenance and testing
Amount of lubricant
(1)
,
maintenance job
1 shot with lever-
type hand gun
See page 9-2
Comments
See page 9-2
Recommended lubricant or
equivalent product as specified in
table of comparable lubricants
SHELL ALVANIA GREASE G2
SHELL ALVANIA GREASE G2
See page 9-2
Lubricating
interval
160
40
See page 9-2
Lubricating points
Central lubricating panel
- All lubricating nipples
without ATS/CNC
with ATS/CNC
See page 9-2
Pos.
10
3, 5, 6
7, 8, 9
Recommended lubricant or
equivalent product as specified in
table of comparable lubricants
Lubricate with non-resinous
grease if required
Amount of lubricant
(1)
,
maintenance job, Test
Drain
Check tension
Function test, all
Emergency OFF
buttons
Disconnect each
isolating guard to
switch off the
machine. Check that it is
impossible to switch on the
machine when any of the
guards is open.
Function test,
all switches
Function test,
spindles must be
braked within
max. 10 seconds
Check easy running,
sharp edges,
wear and dirt
Pos.
11
12
13
14
15
16
17
Comments
Optional. Call
WEINIG service
engineer if
exceeded
Optional
Maintenance
interval,
Test
interval
40
40
80
80
80
80
continuously,
but at least 80
Lubricating points,
maintenance work,
Test points
Pneumatic service unit
Flat belts
Emergency OFF
(not illus.)
Interlocks (not illus.)
All switches (not illus.)
Spindle brakes
(not illustrated).
Note manufacturer's
documentation!
Anti-kickback device
or catcher
(not illustrated)
(1)
To Next Page
Loading...