PergoTex II/ PergoTex II LED
Instructions for assembly
We reserve the right to make technical changes
Insert the octagonal shaft and bolt
into place
Note:
Pay attention to the side on which the
drive must be seated.
1. Insert the complete octagonal shaft
into the left and the right belt pulley
from the inside
(Detail A).
Note:
The two sections of the octagonal shaft
can be pushed together at the
"octagonal shaft connecting piece" and
pressed apart again between the belt
pulleys in the side channel.
2. Push the drive (5) with "end cap
cover drive side" (6) from the
outside into the "side channel end
cap" (7) on the drive side and
mount with 6 countersunk hex head
screws M4x10 Torx (4) (Detail B).
Note:
The two sections of the octagonal shaft
should now be pulled apart to verify that
the drive side and bearing side are at
the arrester with the "end cap cover" (3)
or (6).
3. Bolt the long octagonal shaft piece
(9) to the rest of the octagonal shaft
(8) with 4 self-tapping screws
4.2x16 (10)
(Detail C).
To Next Page
Loading...
