wingtra One - Connect Telemetry Link to Tablet and Power on Wingtraone; Check Battery Voltage; Check Even Takeoff Position; Turn on the Remote Control (RC)

Visuallycheckifpropellersarenotdamagedandwellattached.Trybyhandtounscrewthepropeller:
holdmotorwithonehandandthepropellerwiththeotherhandandtrytoopenit-theredpropeller
hasanormalright-handedthread,thegreenpropellerhasaleft-handedthread.Ifthepropeller
unscrewsbyhand,tightenthenutwiththetorxorhex-wrenchtoolasmuchasyoucan.Seethe
maintenancechapterforhowtoreplaceapropellerifdamaged.
Removethecameraprotectionlid.PutitinthePilotBox,itiseasytolose.
Confirmbyclickingthecheckpointinthechecklist.DonotflyifanypartofWingtraOneisdamaged.
3.ConnecttelemetrylinktotabletandpoweronWingtraOne.
Thispointinthechecklistisanautomatedtest.Connectthetelemetrytothetabletattheentryonthe
rightofthehomebutton.WingtraPilotautomaticallyconnectstoWingtraOneassoonasthetelemetry
isconnectedtothetabletandWingtraOneispoweredon.Ifautomaticconnectioncannotbe
established,youcanmanuallyconnecttoyourvehicleintheSettingstabbyclickingonthe
"Telemetry"buttonontheleftside.Onthebottom,clickon"Add".SelectType"Serial"andBaudRate
"57600"andclick"ok".Ifyoustillcannotconnect,repowerandmakesurethatyouhaveattachedthe
telemetryandpoweredonWingtraOne.
4.Checkbatteryvoltage
Thisisanautomatedtest.WingtraPilotcheckswhetherthebatteryvoltageisabove30V.Ifthevoltage
isbelow30Vtake-offispreventedandyouhavetoswitchbatteries.Inthefollowingfurtherbattery
failurecases,WingtraOnewillrefusetakeoffwhentryingtostarttheflight:
batterytoohot(>40°C(>104°F))
batterytoocold(<10°C(<50°F))
batteriesarenotchargedevenly
5.Checkeventakeoffposition
Thisisanautomatedtest.WingtraPilotcheckswhetherWingtraOneisstandingonevenground.
MoveWingtraOneifthecheckisred.IfWingtraOneislevelandthecheckstaysred,repower
WingtraOne.
6.Turnontheremotecontrol(RC)
SwitchontheRContheOn/OffbuttoninthemiddleoftheRC.Afterswitchingiton,itautomatically
connectstoWingtraOneandyoucanseetheRCbatterychargeandthesignalstrengthofthe
connectiononthetopleftoftheRCscreen.
Thischeckisnotyetautomated,confirmbyclickingthecheckpointinthechecklist.
7.CheckGPSsignals
Thisisanautomatedtest.Dependingontheweatherandthelocation,itcanhappenthatyour
WingtraOnedoesnotreceiveGPSlockforseveralminutes.IfGPSlockcannotbeestablishedafter
morethan5minutes,trytorepowerWingtraOne.Ifyoustillfailtogetreception,submitasupport
request.
8.PressReady-to-FlybuttononyourWingtraOne
Preflight-Checklist
43