wsm L3301 - Page 262

CLUTCH
L3301, L3901, L4701, WSM
2-S15
Bonnet and Side Covers
1. Disconnect the headlight connector (1).
2. Remove the damper (2) from the bonnet.
3. Disconnect the bolt (3) from the bonnet.
4. Remove the bonnet (4).
5. Remove the R.H. and L.H. side covers (5).
9Y1211012ENS0014US0
Rear Bonnet and Stay
1. Remove the steering wheel (1) with a steering wheel puller.
2. Remove the throttle grip (4).
3. Disconnect the main switch (5).
4. Disconnect the combination switch (6).
5. Disconnect the DPF switches (2).
6. Remove the rear bonnet (3).
7. Remove the meter panel (14).
8. Disconnect the DPF alarm (10).
9. Disconnect the flasher unit (13).
10. Disconnect the starter (8), glow plug relays (7) and CCV heater
relay (15).
11. Disconnect the ECU (9).
12. Remove the separator (12).
13. Remove the rear bonnet stay (11).
(When reassembling)
9Y1211012CLS0007US0
(1) Headlight Connector
(2) Damper
(3) Bolt
(4) Bonnet
(5) Side Cover
Tightening torque
Steering wheel mounting
nut
48 to 55 N·m
4.9 to 5.7 kgf·m
36 to 41 lbf·ft
(1) Steering Wheel
(2) DPF Switch
(3) Rear Bonnet
(4) Throttle Grip
(5) Main Switch
(6) Combination Switch
(7) Glow Plug Relay
(8) Starter Relay
(9) ECU
(10) DPF Alarm
(11) Rear Bonnet Stay
(12) Separator
(13) Flasher Unit
(14) Meter Panel
(15) CCV Heater Relay
KiSC issued 09, 2016 A