TRANSMISSION
L3301, L3901, L4701, WSM
3-S23
Adjusting Neutral
• Stop the engine when adjusting the HST neutral.
1. Set the cruise control lever to "OFF" position. (HST pedal is in
Neutral position.)
2. Check to see that the length a of HST control rod (2) and the
length b of neutral rod (6) are specified length.
If not, adjust as follows.
Length "a": 231.2 to 232.2 mm (9.07 to 9.11 in.)
Length "b": 138.5 to 139.5 mm (5.49 to 5.53 in.)
3. Loosen the hex. head screw (3) to make situation that HST
control lever (4) moves freely. Operate the engine for 5 seconds
to make sure that the HST is in neutral position.
4. Tighten the hex. head screw (3) so that the HST control lever (4)
does not turn.
• Be sure to tighten the hex. head screw with specified
torque.
9Y1211012TRS0019US0
Tightening torque
HST control lever setting
hex. head screw
6.9 to 8.3 N·m
0.7 to 0.85 kgf·m
5.06 to 6.15 lbf·ft
(1) HST Pedal
(2) HST Control Rod
(3) Hex. Head Screw
(4) HST Control Lever
(5) Connecting Shaft
(6) Neutral Rod
[A] Right Side View
[B] Left Side View
a: Length of HST Control Rod
b: Length of Neutral Rod
To Next Page
Loading...
