HYDRAULIC SYSTEM
L3301, L3901, L4701, WSM
8-S24
[3] POSITION CONTROL VALVE
Position Control Valve
1. Loosen and remove the position control valve mounting screws.
2. Remove the position control valve (1).
(When reassembling)
• Be careful not to damage the O-rings.
• Measure the distance between the spool edge and spool
joint 2 edge before disassembling.
(To be continued)
Tightening torque
Position control valve
mounting screws
20 to 24 N·m
2.0 to 2.5 kgf·m
15 to 18 lbf·ft
(1) Position Control Valve
(2) Nut 1
(3) Set Screw
(4) Plate 1
(5) Washer
(6) Spring
(7) Spring
(8) Poppet 1
(9) Valve Seat
(10) Valve Body
(11) Sleeve
(12) Backup Ring
(13) Poppet 2
(14) Plug 1
(15) Screw
(16) Spring Holder
(17) Spring
(18) Plate 2
(19) Spring
(20) Poppet 3
(21) Unload Poppet
(22) Spring
(23) Unload Plug
(24) Spool
(25) Plug 2
(26) Nut
(27) Lock Nut
(28) Spool Joint 1
(29) Spool Joint 2
To Next Page
Loading...
