ELECTRICAL SYSTEM
L3301, L3901, L4701, WSM
9-M6
Parked Regeneration Switch
Press the parked regeneration switch (1) under the
specified condition, and the parked regeneration starts.
When specified amount of PM (Particulate Matter)
has built up in the DPF, it is possible to do the parked
regeneration.
9Y1211012ELM0013US0
DPF INHIBIT Switch
Press the DPF INHIBIT switch (1), and the Auto
Regeneration Mode and Regeneration Inhibit Mode are
activated alternately. When the key switch is turned ON,
Auto Regeneration Mode is automatically activated as a
default.
9Y1211012ELM0014US0
Parking Brake Switch
The parking brake switch (1) is attached near brake
pedals. When parking brake is applied, this switch is
turned ON. When the main ECU (Electric Control Unit)
receives ON signal from this switch, the main ECU lights
up the parking brake indicator on the meter panel.
9Y1211012ELM0015US0
Shuttle Switch (Manual Transmission Model Only)
Shuttle switch (1) is attached at the bottom of shuttle
lever. This switch is turned on when the shuttle lever is
in "NEUTRAL" position. This switch also has a function
as a safety switch. If this switch is in OFF position, starter
motor does not rotate.
9Y1211012ELM0016US0
(1) Parked Regeneration Switch
(1) DPF INHIBIT Switch
(1) Parking Brake Switch
(1) Shuttle Switch
To Next Page
