wsm L3301 - Page 72

GENERAL
L3301, L3901, L4701, WSM
G-48
Replacing Head Lamp
CAUTION
To avoid personal injury:
• Be careful not to drop the bulb, hit anything against the
lamp, apply excess force, and get the lamp scratched. If
broken, glass may cause injury.
• Before replacing the lamp, be sure to turn off the light and
wait until the bulb cools down, otherwise, you may get
burned.
 Removing Bulb
1. Remove the rubber boot.
2. Turn the socket counterclockwise while pressing and remove it.
3. Remove the bulb.
 Attaching Bulb
1. Align (A) of the bulb with (B) of the lamp case and attach the
bulb.
2. Align (C) of the socket with (D) of the lamp case and attach the
socket.
3. Attach the rubber boot.
IMPORTANT
• Be sure to use a new bulb of the specified wattage.
• Never touch the bulb surface (glass) with bare hands.
Fingerprints, for example, may break the bulb.
9Y1211012GEG0126US0
Replacing Radiator Hose (Water pipes)
• Replace if any deterioration (crack, hardening, scar of
deformation) or damage occurred.
Refer to "Checking Radiator Hose and Hose Clamp". (See page
G-42.)
9Y1211012GEG0199US0
Replacing Fuel Lines
• Replace if any deterioration (crack, hardening, scar of
deformation) or damage occurred.
Refer to "Checking Fuel Line". (See page G-41.)
9Y1211012GEG0200US0
Replacing Intake Air Line
• Replace if any deterioration (crack, hardening, scar of
deformation) or damage occurred.
Refer to "Checking Intake Air Line". (See page G-42.)
9Y1211012GEG0201US0
Replacing Power Steering Hose
• Replace if any deterioration (crack, hardening, scar of
deformation) or damage occurred.
Refer to "Checking HST Oil Line and Power Steering Oil Line".
(See page G-42.)
9Y1211012GEG0202US0
Replacing Oil Cooler Line
• Replace if any deterioration (crack, hardening, scar of
deformation) or damage occurred.
Refer to "Checking HST Oil Line and Power Steering Line".
(See page G-42.)
9Y1211012GEG0203US0
(1) Rubber Boot
(2) Socket
(3) Bulb
(4) Lamp Case
(A) Align to (B)
(C) Align to (D)
KiSC issued 09, 2016 A