Xerox 4595 - Offset Stacking (Finisher Tray)

Xerox 4595 Copier/Printer System Administration Guide
8-64
8. Setups
Offset Stacking (Finisher Tray)
Select the default offset stacking option for the finisher tray:
• None: If this option is selected, the finishing tray will not offset
any output.
• Offset per set: If this option is selected, the finishing tray will
offset each set of a copy/print job. This option also offsets
each job.
• Offset per job: If this option is selected, the finishing tray will
delivers all the sets of a job in one stack. When the next job
starts, that job is offset from the previous job in the tray. This
option does not offset each set of a job.
3 sets of another job
3 sets
of a
job
3 sets of a job
Job 1
Job 2
(with stacked sets)
(with stacked sets)