Xerox 4595 Copier/Printer System Administration Guide
8-110
8. Setups
Date Position- Bottom Left When selecting Bottom Left under Annotation - Date - Position
in the Output Format screen for printing, you can finely tune the
date position.
Set the position in the horizontal direction within the range 0-100
and in the vertical position within the range 0-100 in 1 mm
increments.
Date Position-Bottom
Center
When selecting Bottom Center under Annotation - Date -
Position in the Output Format screen for printing, you can finely
tune the date position.
Set the position in the horizontal direction within the range 0-100
and in the vertical position within the range 0-200 in 1 mm
increments.
Date Position-Bottom Right When selecting Bottom Right under Annotation - Date -
Position in the Output Format screen for printing, you can finely
tune the date position.
Set the position in the horizontal direction within the range 0-100
and in the vertical position within the range 0-100 in 1 mm
increments.
Page No. Position defaults
You can select the default position that the page number is printed
on the output when the Page No. - Position feature is selected on
the Annotation screen (Output Format tab). There are six page
number position defaults:
• Page No. Position - Top Left
• Page No. Position - Top Center
• Page No. Position - Top Right
• Page No. Position - Bottom Left
• Page No. Position - Bottom Center
• Page No. Position - Bottom Right
Page No. Position-Top Left When selecting Top Left under Annotation - Page Number -
Position in the Output Format screen for printing, you can finely
tune the page number position.
Set the position in the horizontal direction within the range 0-100
and in the vertical position within the range 0-100 in 1 mm
increments.
Page No. Position-Top
Center
When selecting Top Center under Annotation - Page Number -
Position in the Output Format screen for printing, you can finely
tune the page number position.
Set the position in the horizontal direction within the range 0-100
and in the vertical position within the range 0-200 in 1 mm
increments.
To Next Page
Loading...
