Xerox 4595 - Port Settings; Protocol Settings

Xerox 4595 Copier/Printer System Administration Guide
8-118
8. Setups
Port Settings
Select the interface by which the machine is connected to the
client. In Port Settings, you can set the following items:
For information about port settings, refer to the following sections
in this guide:
• Services and features page 5
• Network setting items for CentreWare Internet Services page
5
• E-mail overview page 1
Protocol Settings
Select the parameters that are required for communications
between the machine and client workstations. In Protocol
Settings, you can set the following items:
For information about port settings, refer to the following sections
in this guide:
• TCP/IP (LPD/Port 9100) page 1
• Ethernet page 6
• TCP/IP page 12
1. LPD 9. FTP Client
2. NetWare 10. Receive E-mail
3. SMB 11. Send E-mail
4. IPP 12. Mail Notice Service
5. EtherTalk 13. UPnP Discovery
6. Salutation 14. Internet Services
7 Port9100
15.SOAP
8. SNMP
1. Ethernet Settings 4. TCP/IP - Subnet Mask
2. TCP/IP - Get IP Address 5. TCP/IP - Gateway Address
3. TCP/IP - IP Address 6. TCP/IP - IP Filter