Xerox 4595 Copier/Printer System Administration Guide
1-19
1. Overview
Interface cables
When connecting to a network, use the Ethernet interface.
Using the Ethernet Interface
The Ethernet interface supports the following 2 types:
• 100Base-TX
• 10Base-T
This section describes the installation procedure for the Ethernet
interface.
1. Confirm that the power switch is turned off.
2. Connect a network cable to the Ethernet interface connector.
NOTE: Prepare a network cable suitable for your network
connection. When changing the network cable, consult the
appropriate personnel.
3. Switch on the machine.
To Next Page
Loading...
