Xerox 4595 System Administration Guide

Xerox 4595 Copier/Printer System Administration Guide
4-9
4. E-mail
NOTE 1: Enter address in the format "xxx.xxx.xxx.xxx"
where xxx should be a numeric value in the range from 0
to 255. However, 224 or 225.xxx.xxx.xxx and
127.xxx.xxx.xxx cannot be used.
NOTE 2: When you make an entry mistake, press the C
(Clear) button and enter again.
NOTE 3: When you would like to move to the next value
without entering all 3 digits, select Save/Select Next.
– SMTP Server - Server Name
Enter if By Server Name has been selected for SMTP
Server - Setup.
– SMTP Server - Port Number
Enter a value in the range from 1 to 65535.
NOTE:This configuration is not necessary if SMTP has
been selected for the Mail Receiving Protocol and has
already been configured.
– E-mail Send Authentication
Select one from Off, POP before SMTP, or SMTP
AUTH.
NOTE:If POP before SMTP has been selected, the POP3
settings must be set.
– SMTP AUTH - Login Name
Set this item if SMTP AUTH has been selected for E-
mail Send Authentication.
– SMTP AUTH - Password
Set this item if SMTP AUTH has been selected for E-
mail Send Authentication. Enter the same password
twice in the New Password and Confirm
Password. If you do not wish to set the password,
leave it blank and select Save.
• Select Close.
5. Configure the Domain restriction
Select Domain Filter and set the following items.
• Domain filtering
Select one from Off, Enter Permitted Domain Names, or
Enter Rejected Domain Names.
• Domain 1 - Domain 50
Specify up to 50 domains if either Enter Permitted
Domain Name or Enter Rejected Domain Name has
been selected for Domain Filter.

Xerox 4595 Specifications

General

Brand	Xerox
Model	4595
Category	Copier
Language	English