Xerox 4595 System Administration Guide

Xerox 4595 Copier/Printer System Administration Guide
5-7
5. Using the Scan Service
NOTE 1: Enter address in the format “xxx.xxx.xxx.xxx”
where xxx should be a numeric value in the range from 0
to 255. However, 224 or 225.xxx.xxx.xxx and
127.xxx.xxx.xxx cannot be used.
NOTE 2: When you make an entry mistake, press the C
(Clear) button and enter again.
NOTE 3: When you would like to move to the next value
without entering all 3 digits, select Save/Select Next.
– SMTP Server - Server Name
Enter if Specify by the Server Name has been
selected for SMTP Server - Setup.
– SMTP Server - Port Number
Enter a value in the range from 1 to 65535.
NOTE:This configuration is not necessary if SMTP has
been selected for the Mail Receiving Protocol and has
already been configured.
– E-mail Send Authentication
Select one from Off, POP before SMTP, or SMTP
AUTH.
NOTE:If POP before SMTP has been selected, the POP3
settings must be set.
– SMTP AUTH - Login Name
Set this item if SMTP AUTH has been selected for E-
mail Send Authentication.
– SMTP AUTH - Password
Set this item if SMTP AUTH has been selected for E-
mail Send Authentication. Enter the same password
twice in the New Password and Confirm
Password. If you do not wish to set the password,
leave it blank and select Save.
• Select Close.

Xerox 4595 Specifications

General

Brand	Xerox
Model	4595
Category	Copier
Language	English