Product Overview
Xerox 6204 Wide Format Solution
User Guide
2-51
Cutting Roll Media
The following describes how to cut the lead edge of roll media.
Procedure
1. Open the front doors.
2. Pull out the drawer for Roll 1 or Roll 2.
WARNING: Do not open the Roll 1 or Roll 2 cutter cover unless you are specifically directed to do
so.
3. Press the cutter button to cut the lead edge of the media.
The lead edge of the media is cut.
Note
Pressing the cutter button one time cuts about 8.3 inches (210 mm) of media from the lead edge
of the roll. When the cutter button is held down, the roll media feeds continuously until the cutter
button is released. The roll media is cut when the cutter button is released.
To Next Page
Loading...
