Error Code
477
Problem Solving
15
027-501
O O [Cause] Unable to resolve the POP3 server name when using the
POP3 protocol.
[Remedy] Check on CentreWare Internet Services if the POP3
server settings are correct.
027-502
O O [Cause] Failed to login to the POP3 server when using the POP3
protocol.
[Remedy] Check on CentreWare Internet Services if the user name
and password used in the POP3 server are correct.
027-503
O O [Cause] An error occurred in the POP server.
[Remedy] Try again. If the error persists, contact our Customer
Support Center.
027-504
O O [Cause] An error occurred in the SMTP server.
[Remedy] Try again. If the error persists, contact our Customer
Support Center.
027-513
O [Cause] The machine failed to transfer data using [SMB] of the
[Scan to PC] feature because access to the SMB server
was not permitted.
When the server is Macintosh, a folder with the same
name as the specified file name may exist on the server.
[Remedy] Change the settings so that a file or a folder can be read
and written at the save location.
When the server is Macintosh, change the folder name on
the server, or the file name to be transferred.
027-514
O [Cause] The machine failed to transfer data using [SMB] of the
[Scan to PC] feature because the machine could not
resolve the host name or the server name of the SMB
server when accessing the DNS.
[Remedy] Check the connection to the DNS. Check if the forwarding
destination SMB server name has been registered on the
DNS.
027-515
O [Cause] During the transfer using [SMB] of the [Scan to PC]
feature, accessing the DNS failed because the DNS server
was not set correctly.
[Remedy] Set the DNS server address. Or, specify the destination
SMB server address using its IP address.
Error Code
Category
Cause and Remedy
CPFSMO
* If the error persists after following the listed solution, contact our Customer Support Center. The contact number is
printed on the label or card attached on the machine.
To Next Page
Loading...
