Calibration 125
6. Touch the Standard Color Space button to select the specific color space of the
Xerox DocuColor 242/252/260 printer/copier.
7. Touch the Device Color Space button.
8. Touch Save.
9. On the control panel, push Start to start scanning the charts.
The charts are scanned and measured and a calibration table is created. In the
Spire CX260 Calibration Wizard, the software informs you whether or not the
calibration was successful.
10. In the Calibration Wizard, click Finish.
If the calibration process is successful, two calibration tables are generated:
• Normal: Maintains the gray balance throughout the range of colors in the
print job file
• Saturated: Is the same as the normal table for 80% of the color range; but
from that point on, each color has a greater density
To print a job with a calibration table, see Printing a Job with a Calibration Table on
page 137.
Eye-One Spectrophotometer Calibration
Guidelines for Successful Calibration
To ensure your calibration is as accurate as possible, check the following guidelines
before you calibrate:
• Ensure that your Eye-One spectrophotometer is connected properly.
• Ensure that your Eye-One spectrophotometer is calibrated.
Note: This option is only available for the Pro Basic or Pro Control Station
configurations.
To Next Page
Loading...
Need help?
General
