186 Chapter 8 – Setting Parameters
The Paper Stock Tab
Paper Size
¾ From the Size list, select the desired stock size. If you select Custom:
a. Type the desired height and width.
b. Select the desired feed direction:
• LEF (Long Edge Feed)
• SEF (Short Edge Feed)
Tra y
¾ In the Tra y list, select the desired tray, and load the specific stock in this tray. If
you select Auto, any tray with the specific paper stock is used.
Mixed Paper Size
¾ Select the Mixed paper size document check box if the job contains different
paper sizes.
Media Type
1. In the Media Type list, select the desired media.
Note: Make sure that the paper in the selected tray complies with all the other
paper stock parameters. If the paper in the tray does not match all the paper
stock parameters, the job is frozen.
Ti p : If you selected
Transparency, select the Add interleave check box
to insert a blank page between each transparency. To customize the
interleave, select a different paper size, media type, or tray from the
appropriate lists.
To Next Page
Loading...
Need help?
General
