Setting Parameters in the Job Parameters Window 185
The page’s lead and rear edges are determined just after the page is printed out,
before making any change in page orientation.
¾ Select one of the following:
To print your job in the center of the page, click Center
To set page offsets, click the directional arrows or type Rear and Lead values
¾ To apply page offset values to both odd and even pages, select the Same on
both sides check box.
Image Scale
¾ Perform one of the following:
To print the image original size, select 100% (default)
To fit the image to the selected paper size, select Fit to Paper
To custom size the image, select Custom and type the percent by which you
would like to proportionally increase or decrease the image size
Rotate 180
¾ In the Rotate options area, select the desired options:
Select Rotate 180 to rotate your job by 180°.
Select Mirror to flip an image—for example, when printing on transfer paper
for t-shirt production.
Gallop
Gallop enables the job to start printing before the entire job is RIPed.
¾ Select Ye s and type the number of pages to RIP before printing starts.
Ti p : Use this option to move duplex page data away from the spine.
Note: This feature is only available for the Pro Basic and Pro Control Station
configurations.
To Next Page
Loading...
Need help?
General
