184 Chapter 8 – Setting Parameters
Custom: enables you to select the separations that you want to print for each
sheet for each page of the job.
Print Order
¾ Set the print order to From 1 to N (front to back) or From N to 1 (back to front).
Delivery
¾ Select Face up or Face down as the delivery option.
Collation
¾ Select the Collation option:
Ye s : prints a complete copy of the job before the first page of the next copy
prints
No: prints all copies of each page before going on to the next page
Image Position
This parameter enables you to change the location of the entire printed image on the
sheet (simplex or duplex).
Image position uses the following terminology:
• Rear: the edge of a sheet at which printing stops, near the rear of the printer
• Lead: the edge of a sheet at which printing begins
Note: To collate a document and print the set in the correct order, select Face
Down
and From N to 1, or Face up and From 1 to N.
To Next Page
Loading...
Need help?
General
