Replacing the Battery Backup
195
Replacing the Battery Backup
If the backup battery is dead, the printer’s date and time cannot be retained.
Follow the procedure described below to replace the backup battery.
Note:
It’s very important to protect the printer controller board and any
associated circuit boards from electrostatic damage. In addition, always
handle circuit boards by the edges only.
1 Turn off the printer and
disconnect the power cord and
interface cables.
" If the duplex option is
installed, remove it.
2 Using a screwdriver or a coin,
remove the screw on the back of
the printer.
To Next Page
Loading...
