Description of Menu Items
Phaser® 6180MFP Multifunction Printer
9-15
■ Extel Hook Thresh: Specifies the threshold value for the external telephone.
■ Country: Specifies the country where the printer is used.
Note: Country must be set before faxes can be sent.
■ FWD Error Print: To print the documents failed to transfer when Forward Set Print is
set to Off.
■ Off: Does not print documents that fail to transfer when Forward Set Print is set to
Off.
■ On: Prints documents that fail to transfer when Forward Set Print is set to Off.
System Settings
The System Settings menu is used to configure basic printer settings, such as for alarm and
power saver mode.
■ 2 Mode Power Saver: Specifies if both power saver modes are enabled. When set to
Enabled both Mode 1 and Mode 2 are enabled. When disabled, only Mode 1 is enabled.
■ PowerSaver Timer: Specifies the transitional time of Power Saver Modes 1 and 2 in
increments of 1 minute.
■ Mode 1 (Printer): 1 min. to 60 min. (default is 30 minutes)
■ Mode 2 (System): 5 min. to 120 min. (default is 30 min.)
For details, refer to Power Saver Modes on page 2-10.
■ Auto Reset: Specifies the time the printer waits for further control panel input before
automatically resetting the settings for COPY, SCAN, or FAX and returning to the standby
mode.
■ Alert Tone: Specifies whether to turn on the alarm when an error occurs in the printer.
■ Panel Select Tone (default: Normal)
■ Panel Alert Tone (default: Normal)
■ Machine Ready Tone (default: Normal)
■ Copy Job Tone (default: Normal)
■ Non-Copy Job Tone (default: Normal)
■ Fault Tone (default: Normal)
■ Alert Tone (default: Normal)
■ Out of Paper (default: Normal)
■ Low Toner Alert (default: Off)
■ Auto Clear Alert (default: Off)
■ Base Tone (default: Off)
■ All Tones (default: Normal)
To Next Page
Loading...
Need help?
General
