MicroBlaze Processor Reference Guide 273
UG984 (v2018.2) June 21, 2018 www.xilinx.com
Chapter 5: MicroBlaze Instruction Set Architecture
Pseudocode
if MSR[UM] = 1 then
ESR[EC] ← 00111
else
x
← rB[28:31]
if x >= C_FSL_LINKS then
x
← 0
Mx_AXIS_TDATA ← (rA)
if (n = 1) then
MSR[Carry]
← Mx_AXIS_TVALID ∧ Mx_AXIS_TREADY
Mx_AXIS_TLAST ← C
Registers Altered
• MSR[Carry]
• ESR[EC], in case a privileged instruction exception is generated
Latency
• 1 cycle with C_AREA_OPTIMIZED=0 or 2
• 2 cycles with
C_AREA_OPTIMIZED=1
The blocking versions of this instruction will stall the pipeline of MicroBlaze until the instruction can
be completed. Interrupts are served unless the instruction is atomic, which ensures that the
instruction cannot be interrupted.
Notes
The blocking versions of this instruction should not be placed in a delay slot, since this prevents
interrupts from being served.
These instructions are only available when the MicroBlaze parameter C_FSL_LINKS is greater than 0
and the parameter C_USE_EXTENDED_FSL_INSTR is set to 1.
It is not recommended to allow these instructions in user mode, unless absolutely necessary for
performance reasons, since that removes all hardware protection preventing incorrect use of a link.
To Next Page
Loading...
