EasyManuals Logo

Xilinx Vivado MIPI CSI-2 User Manual

Xilinx Vivado MIPI CSI-2
90 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #67 background imageLoading...
Page #67 background image
MIPI CSI-2 RX Subsystem v4.0 67
PG232 July 02, 2019 www.xilinx.com
Chapter 5: Application Example Design
f. Connect the USB-JTAG programming cable from host PC to JTAG micro USB port of
board.
g. Ensure the board switches and jumpers are in position as shown in Figure 5-5.
Ensure that all SW6 switches are set to the ON position to allow programming from
JTAG.
h. Connect the USB UART and JTAG programming cables to the Windows host
computer where xsdb and hw_server are running.
4. Connect the power supply cable and turn on the ZCU102 board.
Send Feedback

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Xilinx Vivado MIPI CSI-2 and is the answer not in the manual?

Xilinx Vivado MIPI CSI-2 Specifications

General IconGeneral
BrandXilinx
ModelVivado MIPI CSI-2
CategoryReceiver
LanguageEnglish